Crescent Solid Auger Drill Bit CDAG-1341 7/8 Inch Boring Tool (1/4 Quick Release Hex Shank 13 Overall Length High Speed Steel Timber Drilling)

Crescent CDAG-1341 7/8" x 13" Solid Auger Drill Bit with 1/4" Quick-Release Hex Shank

The Crescent CDAG-1341 7/8-inch by 13-inch solid auger drill bit bores tearout-free plumbing pathways, electrical trunk lines, and conduit penetrations through structural timber framing, stacked wall plates, and heavy floor joists. Engineered from triple-sharpened high-speed steel with an optimized precision cutting spur, this heavy-duty wood-boring accessory yields 40 percent more cut cycles per battery charge and penetrates lumber up to 10X faster than conventional spade bits. Outfitted with an expansive 12-inch usable drilling depth, deep dual-flute evacuation channels that eliminate internal chip packing and thermal friction, and an impact-rated 1/4-inch quick-release hex shank, it equips commercial electricians, residential plumbers, and framing carpenters with smooth, continuous boring across cordless impact drivers and standard rotary drills.

Best Used For:

• Plumbing and Potable Water Rough-Ins: Boring clean 7/8-inch clearance holes through framing studs, sole plates, and joists to run 1/2-inch and 3/4-inch nominal PEX, copper water lines, and CPVC pipe without friction binding.
• Heavy Commercial Wiring and Cable Bundles: Drilling continuous stud-to-stud pathways to pull heavy-gauge service entrance cable, multiple Romex runs, or flexible armored metallic conduit.
• Deep Timber Framing and Beam Penetrations: Boring through dense dimensional lumber, engineered glulam headers, and doubled rim joists up to a full 12-inch working depth.

Key Performance & Safety Features

• Triple-Sharpened High-Speed Steel: Heavy-duty cutting edges stay sharp longer when cutting through dense construction timber, boring up to 10X faster than generic flat spade bits.
• 40% More Cuts Per Battery Charge: Reduced-friction flute geometry and low-drag cutting spurs decrease motor draw to extend cordless tool operational life.
• High-Capacity Dual-Flute Evacuation: Deep dual flutes rapidly eject large wood chips away from the cutting spur to prevent bore packing and motor bog-down.
• Extended 12-Inch Boring Depth: Long 13-inch tool length allows tradesmen to bore completely through double top plates and deep wall studs without using an arbor extension.
• 1/4" Quick-Release Hex Shank: Precision-milled quick-change hex base eliminates chuck slippage in drill drivers and locks directly into high-torque cordless impact drivers.
• Precision Spur Clean Cutting Edges: Scored perimeter spurs slice cleanly through wood grains before chip lifting occurs, preventing backside exit breakout.

What's Included

• (1) Crescent 7/8-Inch x 13-Inch Solid Auger Drill Bit (CDAG-1341)

Technical Specifications

Pro-Tip: The 7/8-inch diameter is the trade standard for roughing in 3/4-inch PEX and copper water lines; drill steady without angling the tool body once the lead screw engages to ensure your pipe runs straight through consecutive wall studs without binding.