Diablo Cut-Off Disc DBD040040101F 4 Inch Type 1 (0.040 Thin Kerf 5/8 Arbor Aluminum Oxide Steel Stainless Cast Iron Metal Cutting Tool Wheel)

Diablo DBD040040101F 4" x 0.040" Type 1 Thin Kerf Metal Cut-Off Disc

The Diablo DBD040040101F 4-inch Type 1 flat metal cut-off disc delivers razor-sharp, burr-free straight cuts across structural steel, stainless steel tubing, cast iron pipe, and sheet metal panels. Engineered with a premium aluminum oxide abrasive grain blend and an ultra-thin 0.040-inch kerf profile that reduces power draw and friction on angle grinders, this 15,250 maximum RPM wheel speeds up cutting cycles while extending disc service life. Outfitted with high-tensile multi-layer fiberglass mesh reinforcement and a standard 5/8-inch arbor interface, it equips certified welders, mechanical plumbers, and metal fabrication contractors with clean, spark-controlled metal slicing performance.

Best Used For:

• Thin-Wall Conduit and Tubing Slicing: Slicing stainless steel lines, EMT electrical conduit, and copper pipe with minimal heat discoloration and virtually no burr formation.
• Structural Steel and Rebar Parting: Cutting through mild steel angle iron, threaded rod, solid round bar, and structural framing channel on tight jobsites.
• Auto Body and Sheet Metal Fabrication: Trimming heavy automotive sheet metal, exhaust components, and floor panels cleanly in confined clearances.

Key Performance & Safety Features

• Ultra-Thin 0.040-Inch Kerf Geometry: Slices through dense metals with reduced cutting resistance, minimizing motor bog-down and battery drainage on cordless tools.
• Premium Aluminum Oxide Abrasive Blend: Delivers rapid material penetration and exceptional grain durability under high-friction industrial cutting.
• Multi-Layer Fiberglass Reinforcement: High-tensile woven fiberglass mesh provides maximum burst resistance and operator protection under extreme lateral side loads.
• Type 1 Flat Wheel Architecture: Allows deep, straight-line plunge cuts and flush sectional trimming in narrow workspaces.
• High-Speed 15,250 Maximum RPM Rating: Dynamically balanced body minimizes tool chatter and vibration to improve cutting accuracy and reduce user fatigue.

What's Included

• (1) Diablo DBD040040101F 4" x 0.040" x 5/8" Arbor Type 1 Flat Metal Cut-Off Disc

Technical Specifications

Pro-Tip: Always enter metal cuts at a strict 90-degree angle with light feed pressure; never twist or apply side-load pressure to this ultra-thin 0.040-inch wheel, as lateral friction causes premature edge wear and increases kickback risk.