Freud Circular Saw Blade LU87R006M20 6-1/4 Inch Thin Kerf Ripping Tool 25/32 Arbor 0.098 Width Underpowered Motor Protection Wood Cut

Industrial Thin-Kerf Wood Ripping Blade with TiCo Carbide Teeth and Drag-Reducing Perma-Shield Coating

The Freud LU87R006M20 6-1/4 Inch Thin Kerf Ripping Saw Blade delivers industrial-grade cutting velocity and exceptional motor efficiency on low-horsepower woodworking equipment. Engineered with a narrow 0.098-inch kerf profile, this specialized circular blade minimizes mechanical drag and reduces material waste to allow faster feed rates without stalling underpowered motors. This trade-focused cutting solution resolves motor overheating, severe timber binding, and rough cut surfaces on jobsite table saws and radial arm saws by pairing an aggressive 20-degree positive hook angle with premium high-density carbide teeth. Outfitted with a non-stick Perma-Shield thermal coating and anti-vibration stabilizer vents, this clean-running blade ensures smooth, chatter-free ripping passes through thick softwoods and dense hardwoods.

Best Used For:

• Underpowered Machinery Ripping: Running thick hardwood boards through portable benchtop table saws and smaller radial arm saws without overloading the motor.
• Thick Wood Dimensioning: Executing clean longitudinal rip cuts in solid maple, oak, and pine lumber ranging from 3/4 inch to 2-3/4 inches in thickness.
• Precision Cabinetry Preparation: Processing straight, glue-line ready edges on furniture-grade lumber with minimal material loss.

Key Performance & Safety Features

• Premium TiCo Carbide Blend: Specially formulated high-density titanium cobalt carbide teeth maintain a razor-sharp edge longer during continuous ripping.
• High-Efficiency Thin Kerf: The 0.098-inch kerf width reduces cutting resistance to preserve saw horsepower and maximize motor service life.
• Perma-Shield Non-Stick Armor: Advanced red protective coating reduces blade drag by up to 33% to prevent pitch build-up and heat warping.
• Aggressive Hook Geometry: Features a 20° positive hook angle that enables fast, effortless feeding and rapid chip clearance.
• Laser-Cut Stabilizer Vents: Built-in anti-vibration slots trap noise and prevent blade wobble to yield a smooth, burn-free surface finish.

What's Included

• (1) Freud LU87R006M20 160mm (6-1/4 Inch) Thin Kerf Ripping Saw Blade

Technical Specifications

Pro-Tip: When ripping dense lumber stock near the 2-3/4 inch maximum depth capacity, adjust your saw fence alignment precisely parallel to the blade. This prevents binding on the rising rear teeth, allowing the thin 0.098-inch kerf to track perfectly straight without overheating the plate.