Spotnails Sheathing Staples 6616PG-10M 16 Gauge 7/16 Inch Crown 2 Inch Leg (10000 Count Galvanized Siding Roof Construction Fastener)

Spotnails 6616PG-10M 16-Gauge 7/16-Inch Medium Crown 2-Inch Galvanized Sheathing Staples

The Spotnails 6616PG-10M 16-Gauge 7/16-Inch Medium Crown Galvanized Sheathing Staples deliver high-holding-power structural fastening for roof decking, exterior wall sheathing, subflooring, and siding assemblies. Manufactured from heavy-duty 16-gauge steel wire with an electro-galvanized zinc finish, these 2-inch leg fasteners resist moisture-induced rust and eliminate panel pull-through in dense wood framing. Compatible with standard Senco N-wire style pneumatic staplers, these staples ensure deep holding strength across exterior building envelopes and composite timber panels.

Best Used For:

• Roof & Wall Sheathing: Anchoring 1/2-inch and 5/8-inch OSB or CDX plywood decking directly to structural rafters and wall studs.
• Subfloor Decking Installation: Fastening thick tongue-and-groove underlayment panels to floor joists for squeak-free structural stability.
• Exterior Siding & Fencing: Securing cedar shingles, composite lap siding, and wood fence boards with deep 2-inch timber penetration.

Key Performance & Safety Features

• Medium 7/16-Inch Crown: Maximizes surface clamping contact to prevent fastener pull-through under high shear loads.
• Deep 2-Inch Leg Length: Delivers long embedment depth into timber framing studs to resist uplift and wind forces.
• 16-Gauge High-Tensile Wire: Provides heavy-duty lateral shear resistance required for structural building codes.
• Galvanized Corrosion Resistance: Protective zinc electro-coating shields raw steel from moisture, humidity, and outdoor oxidation.
• Universal Senco N-Style Fit: Fully compatible with 16-gauge 7/16-inch crown pneumatic staplers from Spotnails, Senco, Duo-Fast, Hitachi, and Porter-Cable.

What's Included

• (1) 10,000-Count Case of Spotnails 6616PG-10M 16-Gauge 7/16-Inch Medium Crown 2-Inch Galvanized Staples

Technical Specifications

Pro-Tip: Set your compressor operating pressure between 90 and 100 PSI and test fire into scrap lumber to countersink the 7/16-inch crown exactly flush, preventing fractured top plies in OSB roof sheathing.